|
|
| |
|
|
| |
MERCEDES / PORSCHE
SEE MODEL SECTION |
 |
| PRODUCT
BUILD SPECIFICATION (What you get) |
 |
Carpet
Set |
|
Most of our carpet and boot/trunk sets are tool press cut for
accuracy. Our patterns have been carefully developed for the correct
fit. We bind the carpet edges where the original manufacturer
bound theirs and can hand bind on request. All carpets are fully
sewn and require no sewing or specialized tools for installation.
Wherever possible we use and sew in original style heel pads (please
inquire if available for your model). You can choose from the
four carpet styles which we manufacture/mill so you can satisfy
your requirements based on originality, quality, cost and the
look you like.
|
Seat
Covers |
|
All our seat covers are constructed as original and supplied fully
sewn requiring only installation. We strongly recommend the replacement
of all original seat foams for the very best results. Using old
foams show the distorted "look" of the old seat through your new
seat covers.
| Panels vs Cover |
|
All our interior trim panels are steel die cut for perfect accuracy
every time. All our panels come completely trimmed in vinyl/leathercloth
or as original. If you see the word "complete" in
our product guide, the complete full panel is supplied
ready for installation with no trimming required, i.e. door panel,
rear quarter panels, kick panels. If the word "cover"
is used then pre-cut material is supplied ready for you to install
on your car i.e. dash front fascia panel (vinyl) center console
(vinyl, foam, piping, beading). Pay careful attention to this
if you comparison shop around for your new trim. Not all
our competitors provide interior trim products this way.
Some manufacturers do not supply panels that are difficult to
reproduce and supply only vinyl to recover your old panels. Not
so good if your panels are missing or damaged. They supply yards
of bulk material in a roll, you then have to cut out the pieces
you require using your old material as a guide pattern. But what
if it is missing or in very poor condition? Heritage Upholstery
& Trim eliminate this time consuming and inaccurate way to retrim
your British Classic by supplying all the necessary pieces as
pre-cut pattern for great results.
We realize that most home restorers have limited access to all
the extra bits of materials and fixing hardware necessary for
upholstery. With this in mind we supply all the necessary pre-cut
flat backing foams, new door panel fixing clips, carpet studs
at no extra charge. Sure to save you both time and money.
|
Convertible
Tops, Tonneaus & Boot Covers |
|
All the following weather equipment is hand made in house to exact
original patterns and detail to concours show standards. Please
do not confuse our weather equipment with any that are mass produced.
All our tops/tonneaus and boots include all necessary and correct
"Made in England" fixing hardware.
| |
|
| 
|
|
